Connectivity

 View Only

  • 1.  Ultrix Rosstalk Crosspoint Commands

    Posted 04-20-2021 16:59
    Has anyone gotten Rosstalk Crosspoint Commands to work in #Ultrix now that it is supported in version 4.5?  Typically an XPT command for a switcher requires identifying the "bus".  I'm not sure how to translate that into the Ultrix world.  Any example Ultrix commands would be greatly apricated.  

    ------------------------------
    David Goedhart
    Chapman University Dodge College of Film & Media Arts
    ------------------------------


  • 2.  RE: Ultrix Rosstalk Crosspoint Commands
    Best Answer

    Posted 04-20-2021 20:18
    You are probably forgetting to set the Panel ID (I:#) this is what got me at first.

    This is the command I used to get input 1 to route to output 1
    XPT I:1 D:1 S:1

    You can also specify levels: This is source 8 to out 4
    XPT I:1 D:4 S:8 L:1-17

    The user guide has some examples on page 268
    https://documentation.rossvideo.com/files/Manuals/Connectivity/Ultrix/Ultrix%20User%20Guide%20(2101DR-004).pdf


    Hope this helps! good luck.

    ------------------------------
    Mike Pomerleau
    Ross Video
    ------------------------------

    Original Message


  • 3.  RE: Ultrix Rosstalk Crosspoint Commands

    Posted 04-21-2021 23:52
    Thanks Mike!  That was the problem.  Everything is working great now.  I've got my Elgato Stream Deck set up to change sources to my QC monitor.

    ------------------------------
    David Goedhart
    Television Studio Engineer
    Chapman University Dodge College of Film & Media Arts
    Orange United States
    ------------------------------

    Original Message