Production Switchers

Hello. When I enter Channel #s into the various RossTalk CC commands, none of them seem to source XPression clips into the server channels. As I enter numbers, XPression will attempt to load the clips into Framebuffer 1, 2, 3, and on and on but never directly into the server channel. Is it possible for a CC to freely source any Xpression clip into either server channel?

Discovered some device settings that wasn't properly configured. All set!
#Graphite
#Graphite
#Graphite
#Graphite

Actually, still experiencing a similar issue. In the Video Server devices > Cue > Amp_0.2-S3 will only source Server channel 1. Selecting channel 2,3 or 4 in the CC menu doesn't do anything.
#Graphite
#Graphite
#Graphite
#Graphite

You have to setup the Video BNCs for the correct channels -- IE if input 5 was channel 1 and Input 6 is channel 2 then I need to configure each for the device and then also add the option for the configuration of the channel option to the correct channel.

https://www.rossvideo.com/production-switchers/carbonite-black/carbonite-u/video-tutorial-304/

Just incase here is the Carbonite video for configuring Server channels -- essentially it is the same.
#Graphite
#Graphite
#Graphite
#Graphite

Thanks Les! I'll give this a shot.
#Graphite
#Graphite
#Graphite
#Graphite