Production Switchers

First off, I'm so excited with the youtube tutorials - great job, and a superb resource for us here at MLBam.

I have a question I can't seem to find the answer to on my own. We have come to a point here where we are going to need audio playout off the Media Store on our Carbonite 2M. I have watched your video 'using media stores', and quite obviously hear the associated .wav file. My question is, how do I physically connect the Carbonite to our Yamaha board for playout? While I have some ideas about this, I figure it's better to ask, then to start down a long windy road in the wrong direction.

Thanks,

Joy Huber

Hi Joy,

In the MultiViewer Setup you can assign the ANC Source to be the Media Store that you would like so 1 or 2 and then before you go to the monitor send it through an Audio De-Embedder. If your looking to just use this for Wipes and Effects then instead of using 2 Embedders on both MV you could just assign the ANC Source to M2MW. That source is the ME 2 MediaWipe. That way if you change between MediaStores for Wipes. That way if you select to use 1 then the audio will be routed for 1 then if you select Media Store 2 for the Wipe it will route Media 2 to the Embedder.

Also you can always assign Media Store 1 or 2 as needed via an Aux Bus to an Audio De-Embedder, but why waste the output if your using the MV :)

Les

#Carbonite