I did talk to one of my Ross contacts finally and it isn't possible to take multiple ID's like you can in Tessera over RossTalk. My solution was to fire a Tessera Dashboard button to do what I wanted, which was probably a better solution in the long run anyway.
------------------------------
Chris Schaaf
------------------------------
Original Message:
Sent: 06-27-2023 14:49
From: Garrett
Subject: ASCII Syntax Question
This is past my direct knowledge. My stab at it is that that is not possible. - What I would probably do is try to group your items and then send a take command to the group in sequencer, and then set that sequencer to be a take all command. If that makes sense.
------------------------------
Garrett Hall
Overtime Elite
Original Message:
Sent: 06-07-2023 08:52
From: Chris
Subject: ASCII Syntax Question
I'm using a couple DNF Controls IP Control Buddy button stations for triggering Xpression/Tessera. If I'm firing a single take ID, it works fine. I'm attempting to figure out how to fire multiple take ID's using TAKE 500001_500004 syntax. Here's what I've got in the ASCII message to send and it does not work -
TAKE%20500001%95500004%0D%0A
This message for take ID 2 does work - TAKE%202%0D%0A
I'm a little out of my depth on this stuff, so any insight anyone has would be wonderful!
------------------------------
Chris Schaaf
------------------------------