Production Workflow

 View Only

  • 1.  Could not perform transition because

    Posted 08-10-2015 21:03
    Last week we got upgraded to Vision Switcher 17.3h and Overdrive 12.0.13. Now if we double tap to fast (as fast as we did before the upgrade) into double graphics and a shot we get the following error

    "Could not perform transition because

    Device Transitions may only be used when a MOS Device shot is prepared."

    Is there a tsettings or something on the switcher or Overdrive that can be changed to fix this.


  • 2.  RE: Could not perform transition because

    Posted 01-28-2018 16:56
    We're you able to find anything out on this issue?
    #OverDrive


  • 3.  RE: Could not perform transition because

    Posted 02-22-2018 11:40
    Last week we got upgraded to Vision Switcher 17.3h and Overdrive 12.0.13. Now if we double tap to fast (as fast as we did before the upgrade) into double graphics and a shot we get the following error

    "Could not perform transition because

    Device Transitions may only be used when a MOS Device shot is prepared."

    Is there a tsettings or something on the switcher or Overdrive that can be changed to fix this.



    Hi John,

    Are you double-tapping to set up a graphic before taking a shot, like preparing an OTS before going to the OTS shot? Yout could build a custom to "take a prep" and attach it to the existing MOS CG template, and set it to autorun on-air. This would eliminate the need to double-tap.

    Ian
    #OverDrive