Profile

John Lees

Contact Details

My Content

1 to 10 of 10 total

RE: MLE as output

Posted By John Lees 02-03-2019 17:18
Found In Egroup: Production Switchers \ view thread
Yes you are correct I'll watch the video thanks #Vision

RE: MLE as output

Posted By John Lees 02-03-2019 04:09
Found In Egroup: Production Switchers \ view thread
So I was able to configure the MLE1 to the channel 16 on my output board. So now how do I assign only the Cams 1-3 and SloMo 1-3 to MLE1. I'm fairly new to the video world so my knowledge to the switcher is very limited, I greatly appreciate all the help I get! #Vision

RE: MLE as output

Posted By John Lees 02-03-2019 02:48
Found In Egroup: Production Switchers \ view thread
I'll look into this thank you for your response #Vision

MLE as output

Posted By John Lees 02-03-2019 02:30
Found In Egroup: Production Switchers \ view thread
Can I use MLE1 as an output and MLE2 another output? We are looking to have on MLE1 our 3 cameras and 3 sloMo feeds. On MLE2 we would like the 3 cameras, the 3 sloMo feeds, the Chyron and lastly the Tricaster. Each MLE would have to be able to output content to different locations, MLE1 to internet feed ...

Clean feed?

Posted By John Lees 09-30-2018 03:50
Found In Egroup: Production Switchers \ view thread
I am trying to set up a clean feed that will only show our 3 camera inputs, I don't know if this is possible on our vision switcher? Our frame is a QMD frame. I can't have any of the tricaster, chyron or our 360 image server graphics displayed on this feed. Is this possible on my switcher system?

RE: computers ip address?

Posted By John Lees 09-30-2018 03:43
Found In Egroup: Facility Control \ view thread
Got it thanks for your input #DashBoard

RE: oGx Frame IP address

Posted By John Lees 09-30-2018 03:42
Found In Egroup: Facility Control \ view thread
Thanks everyone I got access to my dashboard now! #DashBoard

computers ip address?

Posted By John Lees 09-23-2018 05:55
Found In Egroup: Facility Control \ view thread
im trying to figure out what i set my computers IP address to so I can access my OGX thru dashboard. I already now the OGX IP address 192.168.2.1, but not the computers. any help would be very helpful. thank you

RE: oGx Frame IP address

Posted By John Lees 09-20-2018 02:50
Found In Egroup: Facility Control \ view thread
I found the answer, you change it by using the dip switches on the MFC-OG3-N card or the Dashboard Network tab. #DashBoard

oGx Frame IP address

Posted By John Lees 09-20-2018 01:32
Found In Egroup: Facility Control \ view thread
My oGx open gear frame is showing an IP address of 0.0.0.0, how can I change this to an IP address of something like 192.168.1.144?