Profile

Arnold Jonas

Contact Details

My Content

1 to 10 of 10 total

RE: Strange behavior when cutting

Posted By Arnold Jonas 01-26-2017 16:16
Found In Egroup: Production Switchers \ view thread
Will try to send to your address right away then - Thanks :) See attached screen shot for email error .... #Carbonite

HDC-8223 board NOT booting

Posted By Arnold Jonas 11-25-2015 14:36
Found In Egroup: Infrastructure​ \ view thread
Hi I have 5 pieces of HDC-8223 boards in a frame, and one of them does not leave the 'BOOT' status on the little display on the board, and it does not appear in the Dash Board software... Slot 2 is not accessable / does not show up at all in Dashboard ... Slot 0, 4, 6, 8, 10 is showing up! ...

RE: Multi viewer Major Problem

Posted By Arnold Jonas 02-10-2015 11:58
Found In Egroup: Production Switchers \ view thread
Hi Cameron When you look at the PGM og MV signals in a waveform monitor, is the signal steady then? I have a Carbonite+ frame, and everything works great with the new 10.0.2, but I know that it is now the same hardware so we cannot compare it 100%... Sorry to hear that you have problems. ...

RE: Multi viewer Major Problem

Posted By Arnold Jonas 02-04-2015 18:15
Found In Egroup: Production Switchers \ view thread
Hi Les! Great - just downloaded it, I will install it in the OB truck tomorrow and hopefully everything works :D I just want to say that it is totally awsome that you guys are so active on the community! Thanks / Jonas #Carbonite

RE: Multi viewer Major Problem

Posted By Arnold Jonas 02-02-2015 13:36
Found In Egroup: Production Switchers \ view thread
Hi Les Any news on when the update will be released? :) / Jonas #Carbonite

RE: Firmware updates

Posted By Arnold Jonas 01-28-2015 14:08
Found In Egroup: Infrastructure​ \ view thread
Hi Mike Thanks, I will do so :) / Jonas #openGear

Firmware updates

Posted By Arnold Jonas 01-28-2015 13:52
Found In Egroup: Infrastructure​ \ view thread
Hi Ross people Where can I make sure that every terminal equipment I've got has got the latest firmware? Can't seem to find anywhere on the page that provide me a download page for terminal equipment firmware... / Jonas

RE: Multi viewer Major Problem

Posted By Arnold Jonas 01-16-2015 21:15
Found In Egroup: Production Switchers \ view thread
Hi Les Thanks for the explanation of the ram player calculation - I know that there are a lot of different factors here, but I would love a chart that states an estimat in all the different formats... But I know it is hard to make it 100% acurate. Back to the firmware: Okay, I will stay ...

RE: Multi viewer Major Problem

Posted By Arnold Jonas 01-16-2015 20:44
Found In Egroup: Production Switchers \ view thread
Hi Les Seems like there is no problems with the 9.1 firmware with the clips I'm using.. I've had 2 x 8 seconds of 1080 TGA sequences running in RAM PLAYER 2 and RAM PLAYER 4 (They share memory) and that works for me... Still, I will download 9.0 from your link, just in case! And can I share ...

RE: Multi viewer Major Problem

Posted By Arnold Jonas 01-16-2015 19:04
Found In Egroup: Production Switchers \ view thread
Hi Les and Steve We've had the same problem when we did load in on one of the RAM players today. Even though the RAM player was NOT selected as MV overlay, it still did some vetical lines with jitter, and then went totally fucked up... Important: After that, the RAM players could NOT play ...