Profile

Hello! Does anybody know if the Ultrix router strips away AES User Bits on the MADI stream if you are routing 1to1 MADI to MADI? My aim is to be able to route Riedel AES Intercom-panel with all panel data which is on the User Bits of the AES signal. All our Ultrix production units is out ...

Thank you for the answer! I understand. My plan was to use a serial to IP converter and back, between the older panel, but i guess the only sensible option then is to use the Carbonet converter? #Carbonite

Hello! Is there someone who knows the specs on the PSL port on the carbonite frames and panels? Is it RS422 or RS232, and which baudrate and so on.

Hello! I am wondering if the Calrec CSCP protocol is supported directly in Carbonite or Acuity mixers without the need for Overdrive? I see that Calrec mixers are supported from the documentation from Overdrive, and in the documentation for Calrec CSCP and Calrec Brio Mixer the wording "support for Ross ...

Ok, Thank you! I have contacted Sony as well and hope they have a solution for this :) #Carbonite

Hello! We are trying to connect our HDC-1700 cameras in 1080P50. We notice with our Phabrix analyzer that the output from these cameras only gives 3G Level B, or either channel of the dual link. The output of Ross gives 3G Level A. Is it possible to set the mixer to Level B?

Hello! I am trying to get an response from CasparCG to show in dashboard somewhere. I have gotten dashboard to send commandoes to caspar just fine via custom rosstalk commands like this: and i can see that Caspar get the commands and respond to them, either play a clip or answers like this: ...

Hello! Finally signed up for the forum! I have a question; As the title says, is it possible to add a hold line, not a pause line? This works well in Carbonite macro functions. Do you have any suggestions? Hoping for an answer! :)