Profile

I see in the manual that it is possible to setup to manually trigger a GPI output via a button on the control surface ... but what if we're operating without a control surface ... i.e. dashboard/rosstalk only... Would love to know if there is a way to do this manual trigger using a rosstalk command ...

I'm working on a custom panel to control our Carbonite switcher. As part of this I'm trying to use local parameters to let the user select which ME/MiniMEs are included in a transition. But I've run into a snag. If I add a toggle button which references a local parameter to a table or abs that is outside ...

I figured it had to be something I forgot to do ... thanks! #Carbonite

I just upgraded one of our 1ME Carbonite switchers to the latest firmware version 11.1.0.13375 ... and noticed that we are missing some functionality in the new Dashboard panels. On the Live Assist - ME page - we are no longer able to see/change the ME Rate or any of the Key Rates... as we were under ...

We just upgraded our firmware to version 8.0.1 - and now can't figure out how to select and assign PGM bus to our higher number AUX (5-8). For example - for AUX 5 - we would hold down buttons for Aux 1 & 4 at the same time - then tap the AUX/PGM button in the bottom row. But now when we hold down 2 Aux ...

I am working on a custom video console/countertop design - and want to do a cutout in the counter for the router and camera RCP units. These are for a future project - so I don't have the units in my possession to measure - and I have searched all over the internet for the exact physical dimensions of ...

That's great! Has a timeline been set yet for when this will be available? Thanks, Stan #Carbonite

We currently use our Ross Carbonite to drive multiple outputs in 2 of our multisite worship venues. These include our 2 main side projectors, large format center projector, several channels of broadcast (to our lobby). The ME is used for the side screens - and the other outputs are driven from AUX outputs. ...