Profile

Only by doing it in XPression Studio not via Dashboard. ------------------------------ Philip Kelnhofer ------------------------------

Hi, I am looking to have a Group in Xpression (a MOS generated rundown), be started via Dashboard then step through the graphics automatically (like 10 seconds graphic), and then loop back to the top when it gets to the bottom. The real sticking point is getting it to automatically go back to the first ...

Is there a way to do source substitution for a clean feed on an Acuity being powered by Overdrive? I am familiar with building these on Grass and Sony switchers, but cannot find what I am looking for on the Acuity. ------------------------------ Philip Kelnhofer ------------------------------

I have run into an issue with this solution. I can assign the alternate Bus Map to ME4 Utility, and I can set ME4 PGMC to U1/U2. My problem is that ME4 Utility does not appear in the Auto-Follow selection (all other ME Utility busses are there). Is this another setting somewhere or a limitation? I can ...

This is exactly what I was looking for. So I guess the best option would be to set my Program C to the Utility Bus. Set the Utility bus to auto follow, but replace ME1 PGMA with ME2 PGMC on the same button. Then set up my "clean" versions of ME1 and ME2 on the PGMC of each MLE? ------------------------------ ...

Trying to figure out how to build a clean feed on the Acuity the same way I would on another switcher. Essentially, I looking for my Clean Feed to take the Clean version of an ME when I take the ME. Basically, if I take ME3 PGMA, on Program, I would like the Clean Feed (Program C) to take show ME3 ...