Profile

I'm looking to solve a variation on this theme. Is there a way to change the output Framebuffer programatically? We have several XPression templates where we would like to output to a different Framebuffer based on the value of a user selected dropdown box. It's easy enough to test the ...

Thank you Louis and Les. I took both of your advice. I ended up using two Caprica systems to talk to a single device using RossTalk. For safety, I enabled the device, sent the message, then disabled the device. Enabling the RossTalk device added 20 frames of delay which was acceptable for this project. ...

I have two Acuities in separate control room that need to send RossTalk commands to the same device. The listening device can only listen on a single port. Does Acuity RossTalk establish a continuous connection to an IP:Port? Or does it connect, send a command, then disconnect? If it's the ...

I have two Acuities in separate control room that need to send RossTalk commands to the same device. The listening device can only listen on a single port. Does Acuity RossTalk establish a continuous connection to an IP:Port? Or does it connect, send a command, then disconnect? If it's the ...

I found another solution with Dashboard 9.2: Using sendMessage with: mem ?:2:? Adding the additonal question mark seemed to make the RossTalk work. Sample Code: rosstalk.sendMessage(acuity_ip, acuity_port), 'mem ?:2:?', function(success, cmd, result, exception)( //*** Display ...

Bryan, You can assign a Background Generator as an input source using Bus Maps. Navigate to: Setup --> Installation --> Bus Maps Assign an input to a Background Generator. BKGD 1 & BKGD 2 should be the first two listed sources. ------------------------------ Kurt Blank ABC ...